Safety Precautions - Nilfisk-Advance E130.3 Repair Manual

Inhalation of aerosols can be hazardous to health. Where applicable use a device in order to

avoid or reduce aerosols production, e.g., a shield covering the nozzle. For protection against
aerosols use a respiratory mask of class FFP 2 or higher.
Always unplug the power plug before cleaning or maintenance and when replacing parts or

converting the machine to another function.
Observe the national safety regulations issued, for example, by the employers liability insur-

ance association, social security institutions, occupational safety and health authorities or oth-
er organizations.
Hold the spray lance firmly with both hands. The spray lance is affected by a thrust of up to

16,4N during operation.
The operator and anyone in the immediate vicinity of the site of cleaning should take action to

protect themselves from being struck by debris dislodged during operation. Wear goggles dur-
ing operation.
Disconnect from electrical power supply before carrying out user maintenance.

To ensure the appliance safety only use original spare parts from the manufacturer or ap-

proved by the manufacturer.
High pressure hoses, fittings and couplings are important for the safety of the appliance. Only

use hoses, fittings and couplings recommended by the manufacturer.
Do not use the appliance if a supply cord or important parts of appliance are damaged, e.g.

safety device, high pressure hose and trigger gun.
The appliance is only intended for cleaning outdoors.

Appropriate ear protection must be used.

Never use the machine in an environment where there could be a danger of explosion. If any

doubt arises, please contact the local authorities.
It is not allowed to clean asbestos containing surfaces with high pressure.

This high pressure washer must not be used at temperatures below 0°C.

Voltage and frequency of the machine (see rating plate) must match the voltage of and fre-

quency of the mains supply.
Only connect the machine to electrical installation made by a certifi ed electrician and com ply

with IEC 60364-1.
It is recommended that the electrical supply to the machine should include a residual current

device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms.

Safety Precautions

Warning!
3
A