Table of Contents
Advertisement
QUICK START GUIDE (CONTINUED)
S
U
ETTING
P THE
The remote is preprogrammed at the factory to
operate an RCA TV, VCR, DVD and satellite receiv-
er, and Pioneer CD and audio devices. To control
devices other than the default brands, perform the
following steps and repeat them as needed for
each device to be programmed; otherwise skip
this section.
Direct code set up
T
O SET UP THE REMOTE FOR YOUR TELEVISION
1. Find your device code in the Manufacturer's
code section (page 46 – 60).
Codes are listed by device type and brand
name. The most popular code for each brand is
listed first.
2. Make sure your television is switched on.
3. Press and release TV.
4. Hold down P for at least 3 seconds. The bottom
of the IR Indicator blinks twice, and a circle
appears around P.
5. Enter your four-digit code using the number
keys. The bottom of the IR Indicator blinks
once after each of the first three digits are
entered. After the fourth digit, it blinks twice to
confirm that a valid four-digit code has
been entered.
6. Aim your remote at your television and press
POWER. If your television switches off, your
remote is ready to control your television.
• I
F YOUR DEVICE DOES NOT RESPOND
EACH CODE LISTED FOR YOUR BRAND
YOUR BRAND OPERATE YOUR DEVICE
12
FOR OTHER OPTIONS
• S
OME CODES ARE QUITE SIMILAR
OR IS NOT FUNCTIONING PROPERLY WITH ONE OF THE CODES
ANOTHER CODE LISTED UNDER YOUR BRAND
• I
F THE ORIGINAL REMOTE CONTROL FROM YOUR
POWER
KEY
• T
O SET UP YOUR OTHER DEVICES
,
ABOVE
BEING SURE TO PRESS THE APPROPRIATE DEVICE KEY DURING
3.
STEP
• R
EMEMBER TO PRESS THE CORRECT DEVICE KEY BEFORE OPERATING
YOUR DEVICE
10 Quick Start Guide
R
EMOTE
.
,
PLAY
PRESS
. O
NLY ONE DEVICE
6-
-O
IN
NE
,
FOLLOW STEPS
. I
F NONE OF THE CODES LISTED FOR
,
"S
SEE
EARCH
. I
F YOUR DEVICE DOES NOT RESPOND
.
POWER
INSTEAD OF
,
FOLLOW THE SAME INSTRUCTIONS
(CD,
AMPLIFIER
:
1
THROUGH
M
"
ETHOD
ON PAGE
,
TRY
VCR
DID NOT HAVE A
DURING STEP
,
,
.)
CABLE
ETC
6
WITH
6.
CAN BE
Hide quick links:
Advertisement
Table of Contents
