Reset Your Universal Remote - Radio Shack 15-303 User Manual

3. Press the device key of the device you want to control (in our example, TV). This key
lights and the device key from step 2 turns off.
4. Enter the new device's 3-digit device code (in our example, the TV code). Pause
briefly between each digit to make sure the remote receives all inputs. The device
key flashes when input is received then turns off if you entered the right code. If the
device key stays lit, enter the next code for your device and brand. Repeat for all
possible codes until the device light turns off.
5. Test that the device (in our example, TV) responds to the new device key (in our
example, the AUX key). Each time you press a key to control the device, the
original device key flashes first, and then the newly assigned key flashes once and
turns off.
6. The remote automatically exits setup mode after 10 seconds. To exit manually,
press the newly programmed device key.

Reset Your Universal Remote

To restore your remote to factory settings, press and hold down SET and then press 0
until the current device key blinks three times.
12