Connecting The Foot Control; Connecting To The Power Supply - Husqvarna 250 Operating Manual

01/23/2008
Conexión del pedal
Among the accessories you will find the foot
control cord and the main cord.
1. Remove the foot control cord.
2. Place the foot control on its narrow side.
Fit the plug into the socket inside the foot
control compartment, push the plug.
3. Push it firmly to make sure it is properly
connected.
This operation is only neccessary the very
first time you are going to use the ma
chine.
4. To correctly turn away the cord, place it
into the slot, see picture.
N.B. Before plugging in, check to ensure that
the foot control Is of "type FR2"
El cable del pedal estO entre los accessorios.
Este cable ha de conectarse al mando de pie.
1. Sacar el cable del pedal.
2. Ponga de canto el pedal. Introducir Ia
clavija pequena el zOcalo dentro del
mando de pie e segUn Ia figura.
3. Controlar que a clavija de contacto estd
bien fija.
Esto solo ha de hacerse Ia primera vez,
cuando se desembala Ia máquina.
4. Para poder desenrollar correctamente el
cable, coloquelo en Ia ranura segun Ia
ilustraciOn.
lAtenclon! Controlar que el pedal tlene Ia
marca "type FP2".
1
2 3
Connecting to the power
supply
Conexión eléctrica
1. When you press the power switch, both the
machine and the light are switched on,
2. Connect the foot control cord to the sock
et in the middle on the boftom right side of
the machine,
3. Connect the main cord to the back socket
on the bottom right side of the machine
On the underside of the machine you will
rind information about the power supply (V)
and the frequency (Hz) Check the power
supply setting in the machine to ensure that
Ihis agrees with the main supply before you
connect the machine.
1. Al pulsar el interruptor principal, so conec
ta Ia mdquina y Ia iluminaciOn.
2. Conectar el cable del pedal en Ia enta
Iladura central abajo en el lado derecho
de Ia mdquina,
3. Conectar el cable de Ia red en el enchufe
trasero, debojo del Iado derecho de ía
mdquina
Debajo del zOcalo estãn indicados Ia tensiOn
(voltaje) y Ia frecuencia (Hz). Antes do co
nectar Ia maquina a red, aseguarse do quo
los valores indicados coincidan con los do ía
red.
I
Connecting the toot control