Unpack Platinum 770; Connecting The Foot Control; Connect To The Power Supply - Husqvarna Platinum 770 User Manual

Learn your Platinum 770

Unpack Platinum 770

1. Place the machine on a table or cabinet, remove the packaging and lift
off the cover.
2. Remove the packing material, the foot control and fi nally the protection cover.
3. The machine is delivered with an accessory bag and a main cord.
4. Wipe off the machine, particularly around the needle and needle plate to remove
any soil before sewing.

Connecting the foot control

Among the accessories you will fi nd the
foot control cord and the main cord. Con-
necting the foot control cord to the foot
control is only necessary the very fi rst
time you are going to use the machine.
1. Take out the foot control cord. Turn
the foot control over. Connect the
cord to the socket inside the space of
the foot control.
2. Push fi rmly to make sure it is pro-
perly connected.
3. Put the cord through the slot on the
right hand side of the foot comtrol.

Connect to the Power Supply

On the underside of the machine you will
fi nd information about the power supply
(V) and the frequency (Hz).
Before plugging in the foot control, check
to ensure that it is of type "FR4" (see
underside of foot control).
1. Connect the foot control cord to the
front socket on the bottom right side
of the machine.
2. Connect the power cord to the rear
socket on the bottom right side of the
machine.
3. When you press the power switch to
ON, both the machine and the light
are switched on.
For the USA and Canada
This sewing machine has a polarized plug (one blade wider than the other). To reduce the
risk of electric shock, this plug is intended to fi t in a polarized outlet only one way. If the
plug does not fi t fully in the outlet, reverse the plug. If it still does not fi t, contact a qualifi ed
electrician to install the proper outlet. Do not modify the plug in any way.
4
3. 1. 2.