IBM xSeries 440 Troubleshooting Manual page 52

Code Function
215 CD-ROM
217 Hard disk drive
264 Magnetic tape
drive
40
xSeries 440:Troubleshooting Guide
Result
Failed On system board.
Aborted The CD-ROM drive is not present.
Failed BIOS drive # n (where n is the drive bay number)
Aborted Test setup error: No tape drive found.
Failed The load/mount test failed for device n on adapter m
(where n is the number of the device and m is the
adapter number)
The Self-diagnostic failed for device n on adapter m.
(where n is the number of the device and m is the
adapter number)
The unload/eject test failed for device n on adapter m
(where n is the number of the device and m is the
adapter number)
The unload/eject push button test failed for device n
on adapter m
(where n is the number of the device and m is the
adapter number)
The Read/Write Self-diagnostic failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
Description Action
Call for service.
Verify that the cables
are properly connected
to the CD-ROM drive. If
the problem persists,
call for service.
Call for service.
Check the cable and
power connections to
the drive.
See the information that
is provided with the tape
drive.
If the problem persists,
call for service.
Refer to the information
provided with the tape
drive.
If the problem persists,
call for service.
Note: The push button
test is
applicable only
to SCSI tape
drives that have
a push button.
Insert a new tape
cartridge; then, run the
diagnostic test again.
See the information that
is provided with the tape
drive.
If the problem persists,
call for service.