Connection Form And Cables; Serial Connection - Epson TM-J7100 Developer's Manual

Confidential
Press the FEED button the number of times required to select the desired auto carriage return
setting.
Press FEED button
0 times:
1 time:
2 times:
3 or more times:
❏ Interface reset signal
Pins #25 and #6 on the RS-232 I/F circuit board unit (UB-S01/02) are used to input the reset
signal. This item is used to "Enable (acknowledge)" or "Disable (not acknowledge)" input of the
reset signal from one of these pins. Press the FEED button the number of times required to select
the desired interface reset signal setting.
Press FEED button
0 times:
1 time:
2 times:
3 times:
4 times:
5 or more times:

Connection Form and Cables

Serial Connection

When the TM printer is connected to the host PC with a serial interface, the following connection
forms are possible:
• Stand alone
• Y-connection
• Pass-through connection
2-12 Adjustments and Settings
Setting select ed
No change
Enabled
Disabled
No change
Setting selected
Pin #25
No change
Disabled
Enabled
No change
Pin #6
Disabled
Enabled
Disabled
Enabled
Rev. A