Parts List - World Dryer XA5 User Manual

Heavy duty hand dryer xa series dxa series a series da series
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
REPLACEMENT OF MOTOR BRUSHES
1. Remove locking spring clip securing brush holder.
2. Draw brush cap out of motor slowly until wire connector appears.
3. Detach wire connector and remove brush and holder assembly.
NOTE: When unpacking brush assembly from carton it is important to hold carbon brush in brush holder securely. P/N206NL
4. Insert new assembly to point where wire quick connect connection can be made.
5. Push brush quick-connects on motor and brush sleeve together.
6. Push brush assembly back in place and insert locking spring clip.
REPLACEMENT OF HEATING ELEMENT
1. Remove three screws holding blower housing (#211P and #112P) together, and remove #112P side of housing.
2. Disconnect the white wires of the heating element at the terminal block and switch terminal. Replace with the new heating element
of proper voltage and wattage, being careful to connect it identically to the old one.
3. Hold element in position on stationary side of blower housing and slip removable side in place, making sure element frames fit into
grooves in blower housing and both wires run through notch at top of air outlet. Reinstall the protective screen and replace three
screws fastening blower housing together.
4. Reconnect wires to terminal block and switch. Make certain all wires are properly reconnected and match the wiring diagram.
REPLACEMENT OF SWITCH TIMER ON PUSH-BUTTON MODELS
1. Remove screws from each of the two terminals on switch timer, marking wires for correct reconnection to switch terminals.
2. Replace defective timer with new one. (Specify Dryer Model when ordering Timer.)
3. Reconnect wires to terminals.
4. Replace cover (be sure cover fits squarely over base unit) and push in until cover is flush with wall and insert two cover mounting
screws. Do not over-tighten the mounting screws.
5. Turn on power to dryer.

Parts List

For Repair Parts, visit
www.WorldDryer.com.
Please provide following
information:
Model number
Serial number
Part description and
number shown in parts list
12
11
10
19
18
17
13
14
9
16
15
6
Figure 2 - Repair Parts List For
7
Hand Dryers
8
4
1
2
20
5
3
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents