Module (Valid For Intel® Server Chassis); Reinstall The Raid Controller On The Motherboard; Server Chassis) - Intel RMFBU4 Quick Installation User's Manual

General Installation Process
11
Connect the RMFBU4 Module to the
Remote Super Capacitor Pack Module
(Valid for Intel® Server Chassis)
A
Ground yourself, and make sure that the system is grounded.
B
Place the RAID controller on a flat, clean, static-free surface.
C
Remove the cable that is included in the RAID controller box.
D
Insert one 9-pin cable connector on the cable into the 9-pin J1
connector on the RMFBU4 module, as shown in the following
figure (the cable is blue).
E
Insert the other 9-pin cable connector into the 9-pin connector on
the remote Super Capacitor Pack module.
Align the cable connectors to make sure that they are connected
correctly.
J1
Intel ® RAID Controller
RS3DC080 as shown
RMFBU4 module
12
Reinstall the RAID Controller on the
Motherboard (Valid for Intel® Server
Chassis)
A
Make sure that the power to the chassis is still turned off, the power
cords are unplugged, and the chassis is grounded and has no AC
power.
B
Install the RAID controller in a PCIe slot on the motherboard, as
shown in the following figure.
NOTE: This RAID controller is a PCIe x8 card, and it can
operate in x8 or x16 slots. Some PCIe slots, however, support
only PCIe graphics cards; if a RAID controller is installed in
one of these slots, the RAID controller will not function. Refer
to the guide for your motherboard for information about the
PCIe slot.
C
Press down gently, but firmly, to seat the card correctly in the slot.
D
Secure the RAID controller to the computer chassis with the bracket
screw.
Bracket
Screw
Press
Here
RMFBU module
Edge of
Motherboard
E
Reinstall the computer cover, and reattach the power cords.
F
Turn on the power to the computer.
Refer to the Intel ® RAID Software User Guide for information about
running the RAID configuration utility and installing the software
drivers.
6
Intel ® RAID Controller
RS3DC080 as shown
Press
Here
PCIe Slot