Exploded View/ Part Location - Thermostat - KSR Moto T58 - ZION 125 Repair Manual

EXPLODED VIEW/ PART LOCATION - THERMOSTAT

2
1
THERMOSTAT AND SECONDARY AIR SYSTEM INSTALLATION
1. Install the parts in reverse order.
2.
3. Do not forget the cooler.
4. Remove the bleed screw (1) to bleed the system.
5.
6. Tighten the screw (1) and start the engine till the large circuit open.
7.
screw (1).
! WARNING
The coolant is very hot
ENIGNE INSTALLATION
1. Install the engine in reverse order.
2.
TORQUE LIST - ENGINE
Fastening area and fastener name
Cylinder cover nut
Oil-discharge bolt
Spark plug
Mould assembling bolt
Variable-speed chamber bolt
Oil pump chain wheel bolt
Right-cover stud
7
5
4
6
3
PART LIST - THERMOSTAT
1. Screws
2. Bleed screw
3. Thermostat-room body
4. Sealing ring
8 5. Thermostat component
6. O-type ring
7. Sensor component
8. Upper cover of thermostate room
INSPECTION - THERMOSTAT
Initial startup temperature
Full-open temperature
Lift in full-open state
Tightening torque [Nm]
25-28
22-25
10-15
10-12
10-12
10-12
10-12
10-12
50-60
10-12
10-12
ENGINE
72-84°C
Over 4.27 mm
1
77