Front/ Rear Brake Light Switch Replacement - KSR Moto T58 - ZION 125 Repair Manual

ELECTRICAL SYSTEM/ SWITCHES AND SENSORS

FRONT/ REAR BRAKE LIGHT SWITCH REPLACEMENT

1. Remove the front handlebar cover.
2. Disconnect the cables of the front/ rear brake light switch.
3. Before replacing the front brake switch, double check its
function (See above).
4. Remove the screw (1) to remove the front/ rear brake light
switch.
NOTE
Pay attention when assembling the switch of the groove and the
notch.
FUEL LEVEL SENSOR INSPECTION
5. Remove the middle cover.
6. Disconnect the fuel level sensor cable (1).
7. Remove the four screws (2) to remove the fuel level sensor
(3).
8. Measure the resistance value between the terminals (4).
If the measured values do not match the standard value
replace the sensor.
10. Check the gasket (5) before reassembling.
11. Assembling in reversed order.
LEVEL
FULL
3/4
1/2
1/4
EMPTY
200
EMERGENCY CUTOUT SWITCH INSPECTION/ REPLACE-
MENT
1. Remove the under vehicle protection, the left front sidecover
and the leg protection.
2. Disconnect the cable (1) coming from the switch.
3. Use a continuity tester to measure the switches as shown in
the illustrations below.
4. In case of damage the switch need to be replaced.
Side stand down
Side stand up
1. To remove the emergency cutout switch (2), disconnect the
cable (1) and remove the two screws (3).
2. Reassemble in reverse order.
± 10%
7
± 10%
36
± 10%
50
± 10%
± 10%
Dg R/W
1
2
4
1
R/W
Dg
2
3
1
5
3
121