Table of Contents
Advertisement
7.2.2. Outer cover
• Step 1: Remove the shaping air assembly
1
Outer cover
2
O-ring
3
Shaping air shroud
• Step 2: Leave to soak in solvent the outer
cover for one hour, then clean the outer
and inner surfaces using a rag soaked in
solvent.
• Step 3: Using a nylon brush, clean all the
holes located on the front face of the outer
cover.
• Step 4: Dry carrefully with compressed air
insisting on the holes to eliminate the paint
residues, then wipe with a clean, dry rag.
• Step 5: Check the shaping air shroud, clean
it if necessary using a rag soaked in solvent.
7.2.3. Injector and injector holder
• Remove the injector
• Leave to soak for one hour in MEK solvent (methylethylketone).
• Dry carefully with compressed air
• Proceed in reverse order to reassemble.
Index revision : F - November 2017
see § 6.6 page 28
3
2
1
Solvent
33
7012
Advertisement
Table of Contents
