Table of Contents
Advertisement
Cleaning procedures
7.
Before any operation, refer to the health and safety rules
According to the frequency of use and in all the cases at the end of each cycle
• Stop the atomizer and switch off the power supply.
WARNING : Always wear safety goggles.
Whenever solvent is handled, rubber gloves must be worn.
Work in a well ventilated area whenever solvent is used.
WARNING : It is imperative to pass a rag soaked with water on the atomizer before cleaning it
using a rag and an approved cleaning product. Do not use a manual solvent gun.
WARNING : Do not soak the turbine in solvent.
Under no circumstances must the atomizer or any of its components be sprayed with solvent or
water at high or low pressure.
WARNING : SAMES KREMLIN disadvises the use of anti-static plastic films to protect bodies
and insulating covers of the atomizers. These films are conductive and can short-circuit the high
voltage.
SAMES KREMLIN forbids the use of adhesives on the insulating parts of the atomizers. The
glue of the adhesives is conductive and thus can short-circuit the high voltage.
SAMES KREMLIN also forbids the use of absorbent textile cover to protect bodies and insu-
lating covers of atomizers. Textile covers retain the cleaning products and paint what can gen-
erate problems of high voltage (drilling, ionization, degradation of the material...).
Thus, SAMES KREMLIN recommends the use of insulating grease for protection of the atom-
izers.
In any case, insulating protection means must be used to prevent the slightest risk of current
overconsumption.
This is why, insulating protection means must be renewed on a regular basis.
Procedure
A
B
Index revision : F - November 2017
Components
Outer cover, bellcup exterior.
Bellcup, shaping air assembly, injector
(see § 1.4 page
30
6).
Frequency
8 hours
120 hours
7012
Advertisement
Table of Contents
