Atomizer maintenance
6.
WARNING : These different operations are to be carried out by a trained person.
6.1. Disassembly and reassembly of the PPH 308
6.1.1. Disassembly
Carry out a rinse of the PPH 308 before disassembly.
• Switch off the UHT 155 power supply.
• Use the wrench (Ref.:1308689) to loosen the cover.
• Unscrew the cover by hand and remove it.
• Loosen the screw securing the UHT 155 to its sleeve
• Disconnect all the hoses to the manifold and 1-PV block (except the hoses between the
1-PV block and the manifold
• Remove the 4 screws securing the PPH 308 to its support.
• Remove the UHT 155 from its sleeve.
WARNING : Leave the grips in place on the manifold to avoid losing them.
6.1.2. Reassembly
• Insert the UHT 155 in its sleeve and secure it with the screw(see § 6.8 page 29).
• Secure the PPH 308 with the 4 screws.
• Reconnect all the hoses to the manifold and 1-PV block.
• Refit the cover by hand and secure it with the wrench (Ref.:1308689).
6.2. Bellcups
For the assembly and disassembly of a bellcup
6.3. Shaping air assembly
For the assembly and removal of a shaping air assembly
6.4. Turbine
see RT Nr 6350
See manual enclosed.
Index revision : F - November 2017
(see § 2 page
see RT Nr 6285
see RT Nr 6285
27
15).
7012