Injector Holder; Injector; Disassembly; Reassembly - SAMES KREMLIN PPH 308 User Manual

6.5. Injector holder

The injector holder is secured to the body of the PPH 308 by three M3 x 10 screws.Its positioning
pin ensures correct fitting.
1 Injector holder
2

Injector

3 Bellcup
6.6. Injector

6.6.1. Disassembly

• Switch off the machine.
• Remove the bellcup
• Remove the outer cover.
• Remove the shaping air shroud.
• Unscrew the injector (Caution: left thread), using a 5-mm flat wrench.
• Cleaning (see § 7 page

6.6.2. Reassembly

• Place the injector in the injector holder and tighten in the clockwise direction to a tight-
ening torque of 3,5N.m.
• Put in place the shaping air shroud.
• Install the bellcup.
• Put in place the outer cover.
• Switch on the power supply.
Index revision : F - November 2017
(see RT Nr 6285).
30).
28
2
1
3
7012