The Remanufacturing Process - Canon imagepress C7000VPE Service Manual


2.

The Remanufacturing Process

1.
2.
3.
4.
5.
6.
7.
8.
9.
This model brings the following capabilities to commercial printers, In-plant
Central Reproduction Department (CRD) facilities, quick printers and digital
printers:

A Segment 5 device that prints and copies Color and Black & White
(B&W) sheets at speeds of up to 70 ppm (pages-per-minute).

Prints images at up to 1200 dpi (dots per inch) x 1200dpi with 256
halftones resolution.

A maximum paper size of 13" x 19.2" is supported. Standard paper
sources two paper trays with a capacity of up to 1,000-sheets each.
Adding the optional POD Deck-A1e, the device can hold a maximum of
6,000-sheets.

Canon's oil-free V Toner utilizes exceptionally small particles containing
micro-dispersed wax so toner fixes evenly and lays flat, resulting in
sharp, vivid, dense images and a smooth finish that looks and feels like
offset printing.
imagePRESS C7000VPe Service Guide
Usability:
The mechanical adjustment for paper skew can be made from
o
the User Interface.
Auto-ejection Feature will clear media from a jam to collect in
o
either the POD Escape tray, Duplex Paper Path or the Saddle
Finisher Tray
All safety related parts are replaced (power cords, breakers, fuses,
thermostats and protective switches).
Pertinent engineering changes are implemented (updated parts,
firmware, etc.).
Hard disk drives are replaced or erased and reimaged.
Each module is inspected for damage during the remanufacturing
process. Subassemblies and parts are replaced as needed.
All paper path areas are thoroughly cleaned, and evaluated during
the reassembly process.
Almost all bearings are replaced in the Main Station, Finisher and
Sub Station. All bearings are replaced in the fixing units.
The fixing units are completely disassembled, cleaned and tested.
The fixing unit tests are the same as for a newly manufactured
fixing unit: a belt alignment test, pressure spring force test and a
complete function check test (checks sensors, web advancement,
temperature, refresh and cleaning roller engagement and belt
timing).
All of the reworked major sub-assemblies are inspected by the
operator performing the rework as well as an inspector.
After the entire module has been reworked and re-assembled it is
inspected as an assembly.
imagePRESS C7000VPe Service Guide
April 2013
Page 2