Anton Sprint eVo User Manual page 13

Sprint eVo 1 /eVo 2 /eVo 3
1. Select Pressure Menu from the Test Menu. From
the Press Menu screen options select Pressure, Diff
Pressure. Working pressure or Operating Pressure.
2. Connect tube(s) to pressure inlet(s).
3. Zero pressure, use the soft key marked
4. Connect tube(s) to pressure source(s) to
begin pressure test.
5. There is an option to time this test, Sprint
displays the duration time on the screen.
Press the soft key
6. To stop timed test press the soft key
7. To restart test press the soft key
To re-zero the unit, press
Press the ESC key to return to the Press Menu screen. To perform the other
pressure tests repeat steps 2 to 7 above.
Press ESC to return to the Test Menu.
4. Differential temperature test
Sprint can perform a differential temperature test with one or two thermocou-
ple probes. To begin test, select Diff Temperature from the Test Menu. Check
the units displayed are the correct temperature scale. If no probes are con-
nected Sprint will display ####.
Two probe test
Connect both probes to the k-type connectors. See label on back of unit for
FLOW and RETURN. Place probes in position. The screen will display the tem-
perature of probe 1 and probe 2, and the differential
temperature.
Use the soft keys to log or print the results.
To end test press the ESC key.
Single probe test
When only a single probe is available, Sprint will display
an additional icon on the screen to represent the first and
second reading.
1. Place probe in position to make measurement T1.
2. Press the soft key icon
of T1. (Do not remove probe until this snapshot is
taken.)
P=0
to start test and timer.
u
.

.
tt
.
P=0
to take a snapshot reading
T1
T2
Performing tests
Tip: plug in the
Thermocouple
probe to view
temperature on
screen.
.
Pressure
14:44:27
08-Feb-2006
Pressure
0.0
mBar
Duration 00:00
?
P=0
Temperature
14:44:27
08-Feb-2006
Flow T1
C
Ret T2
C
Diff temp
C
?
Tip: this icon
will appear when
only one probe is
avaialble.
Tip:
optional
timer
####
####
####
T1
T2
T1
T2
11