Anton Sprint eVo User Manual page 10

Performing tests
Performing tests
From the Main Menu select Test Menu. Refer to section III Operation for more
details.
Warning: During testing, ensure the combined filter and water trap is not blocked or
full. Failure to do so may result in an error message.
1. Flue gas analysis
Before performing the flue gas analysis test, check the water trap is clean and
is upright (arrow should point in direction of gas flow). To begin test, select Flue
gas analysis from the Test Menu.
Sprint will switch carry out an auto
zero then if successful will begin
making measurements. Check the
fuel type displayed on the screen is
correct. Use the soft keys to log or
print the results.
Press the ON/OFF/ENTER button to
display the three screens available:
Screen 1: CO, CO
2
ratio. Pressure (eVo
only)
Screen 2: O , excess (XS) air,
2
temperature and efficiency.
Final screen: combines elements from previous screens.
To perform a pressure zero (eVo
on the relevant screen
To scroll through the efficiency options, use the soft key marked η.
Screen 1
8
14:44:27
CO
CO2
Ratio
Pressure
, CO/CO
2
2 3
and eVo
2 3
and eVo
Screen 2
Sprint eVo 1 /eVo 2 /eVo 3
1
Flue Gas
08-Feb-2006
Natural gas
Tip: The screen
15
number is
ppm
displayed here.
4.8
%
0.003
Tip: If # symbol
is displayed -
0.00
mBar
flue probe is
?
not in flue or
P=0
not connected.
Tip: Press the
ON/OFF/ENTER
button to cycle
ESC through the
screens.
only), use the soft key marked
Screen 3
P=0