Electrolux W4400H Service Manual page 121

PAUSE TEST LEVEL
PAUSE TEST TEMPERATURE
DEFAULT TEMPERATURE HYSTERIS
TEMPERATURE STEP IN COOL-DOWN
DEFAULT LOW EXTRACT TIME
DEFAULT MEDIUM EXTRACT TIME
DEFAULT HIGH EXTRACT TIME
DEFAULT DRAIN TIME
DEFAULT DISTR. TIME
DO UNBALANCE MEASUREMENT
DRAIN OPEN DELAY
START EXTRACT TIME
ROLLOUT TIME
PAY PER WASH ALARM
1
4
7
DEFAULT TEMPERATURE HYSTERIS
TEMPERATURE STEP IN COOL-DOWN
DEFAULT LOW EXTRACT TIME
DEFAULT MEDIUM EXTRACT TIME
DEFAULT HIGH EXTRACT TIME
DEFAULT DRAIN TIME
DEFAULT DISTR. TIME
DO UNBALANCE MEASUREMENT
DRAIN OPEN DELAY
START EXTRACT TIME
ROLLOUT TIME
PAY PER WASH ALARM
LOCK TEST DELAY
DRAIN TIME WHEN OVERFILL
Y/N
Programme unit
0
-18 °C
4 °C
4 °C
00:00
00:00
00:00
00:00
00:00
N
0:1
00:0
00:01
0
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
4°C
4 °C
00:00
00:00
00:00
00:00
00:00
N
0:1
00:0
00:01
0
0:10
0:05
Answer Yes (Y) or No (N).
Press .
Default values for re-start after unbalance
Here you determine the drain time and distribu-
tion time the machine will use if it cannot find the
time parameters it requires, e.g. during manual
operation of the drain in a washer extractor with a
suspended drum.
Unbalance measurement
Here you determine whether the machine will cal-
culate unbalance before it accelerates to extraction
speed. Drum unbalance can only be calculated in
washer extractors with suspended drums. It uses
torque data from the motor control unit to deter-
mine whether the imbalance is too high.
For washer extractors with suspended drums wit-
hout frequence control and which have a separate
unbalance switch, the answer to this question
should be No.
If you answer Yes (Y):
The machine will calculate unbalance before
every extraction sequence.
If you answer No (N):
The machine will not calculate unbalance.
121