Multitech MultiModemDSVD User Manual page 49

4 AT Commands, S-Registers, and Result Codes
Distinctive
Command: ** n Flash Memory Download
Values: n = 0, 1, or 2
Description: **0 Initiate download to flash memory at the last sensed speed
**1 Initiate download to flash memory at 38.4K bps
**2 Initiate download to flash memory at 57.6K bps
Command: #CID= n Caller ID
Values: n = 0, 1, or 2
Default: 0
Description: Enables or disables Caller ID recognition and reporting.
#CID=0 Disables Caller ID.
#CID=1 Enables formatted Caller ID reporting of ICLID SDM (Single
Data Message) and MDM (Multiple Data Message) packets.
#CID=2 Enables unformatted Caller ID reporting of any ICLID packet
received after the first RING cycle, including SDM, MDM, or
call waiting packets.
#CID? Retrieves the current Caller ID mode from the modem.
#CID=? Returns the mode capabilities of the modem in a list with each
element separated by commas.
Command: +++AT<CR> Escape Sequence
Values: n/a
Description: Puts the modem in command mode (and optionally issues a
command) while remaining online. Type +++AT and up to ten
command characters, then press ENTER. Used mostly to issue
the hang-up command: +++ATH<CR>.
ring type Ring cadence detection criteria
1 2.0 sec. on, 4.0 sec. off
2 0.8 sec. on, 0.4 sec. off, 0.8 sec. on, 0.4 sec. off
3 0.4 sec. on, 0.2 sec. off, 0.4 sec. on, 0.2 sec. off, 0.8 sec. on, 0.4 sec. off
41