To Answer A Dsvd Call; References - Multitech MultiModemDSVD User Manual

To Answer a DSVD Call

1. In the terminal window of your communication application, type AT and press
2. Type AT&F and press ENTER to reset the modem to its default configuration.
3. When the modem responds by displaying RING on the screen, type ATA and
4. When you see a CONNECT response on your terminal, you can pick up the
5. To hang up, type +++ATH and press ENTER.

References

The World Wide Web is an excellent source of information about modems in general
and modem installation, configuration, and troubleshooting in particular. The fol-
lowing Web sites are good places to start:
• Costmo's Other Resources Page:
• Curt's High Speed Modem Page:
• Data Communications FAQ:
• Multi-Tech Systems, Inc.:
Note: If DSVD is enabled, the modems will not connect if the V.34 connect rate
is below 12000 bps. The voice link is not maintained in data mode, so if +++ is
typed and the user goes back to data mode, a simulated busy is played to both
modems to tell the users to place their handsets on hook. If you get an ERROR
message when dialing or answering a call, check to make sure the lines are not
in the wrong jacks. A DSVD data connection is terminated by dropping DTR (if
enabled by &D2) or by issuing +++ATH.
ENTER. The modem responds OK.
This action ensures that the modem is in automatic DSVD mode.
press ENTER to answer the call.
phone and talk to the remote user while simultaneously receiving data from the
remote modem.
http://modems.rosenet.net/
http://elaine.teleport.com/~curt/modems.html
http://www.best.com/~malch/comfaq.html
http://www.multitech.com/
2 Quick Start
17