Field Data Of Iso Transponders - Siemens SIMATIC RF300 System Manual

4.2.2

Field data of ISO transponders

Observe the following information for field data of ISO transponders:
● A maximum median deviation of ±2 mm is possible in static mode (without affecting the
● The field data are reduced by approx. 15% if the transponder enters the transmission
RF310R reader
Table 4- 14 RF310R reader
Length of the transmission
window (L)
Operating distance (S )
a
Limit distance (S )
g
All values are in mm
Combination with the RF310R is basically possible, but is not recommended because the antenna geometries for the
1)
reader and transponder are not ideally matched.
RF380R reader
Table 4- 15 RF380R reader
Length of the transmission
window (L )
x
Width of the transmission
window (L )
y
Operating distance (S )
a
Limit distance (S )
g
All values are in mm
Only the MDS D139 with MLFB 6GT2600-0AA10 is compatible with SIMATIC RF300.
SIMATIC RF300
System Manual, 01/2009, A5E01642529-03
field data)
window laterally (see also "Transmission window" figure)
MDS D100
50
2...78
90
MDS D100
160
100
15...170
210
4.2 Field data for transponders, readers and antennas
MDS D124 MDS D139
30
1)
2...22
30
MDS D124 MDS D139
100 155
80 90
0...72 15...160
90 200
RF300 system planning
MDS D160 MDS D324
36 40
2...25 2...30
37 38
MDS D160 MDS D324
120 130
40 60
0...64 0...96
80 120
47