Axminster HBS200N Manual page 8

Assembly
Twist the locking lever clockwise to adjust the
clamping tension.(two rotations should be adequate)
then press down the lever to lock the fence in
position, see figs 07-08.
Fig 07
Fence rail "T" slot
Fig 08
Step 4 Locate the angled bolt (K), screw the
threaded end of the bolt into the threaded hole to
the top of the bandsaw frame and, using the supplied
10mm spanner, tighten with the nut to lock the bolt
in position, see fig 09. Find the push stick (F) and
hook it onto the angled bolt (K), see fig 10.
Step 5 Locate the optional mitre fence assembly (E)
and slide it into the table's "T" slot, see fig 11.
Fig 09-10
D
Clamping lever
K
F
Table "T" slot
Securing the Bandsaw
Step 1 Place the bandsaw on a work bench. Mark
the position of the holes in the bandsaws base,
place the bandsaw to one side and drill the holes.
Step 2 Line up the holes and secure the bandsaw in
place with bolts, washers and shake proof nuts.
8
Fig 11
E
305mm
330mm