Axminster HBS200N Manual page 7

Hobby series, 200mm
Table of Contents

Advertisement

Step 1 Locate the bandsaw table (B), the four M6
bolts (G) and shake proof washers (H). Slot the blade
into the table's slot and line up the threaded holes
in the table with the pre-drilled holes on the tilt
quadrant, see fig 02.
Fig 02
Step 2 Place a shake proof washer (H) over each M6
bolt (G),screw the bolts through the tilt quadrant into
the table and tighten using the supplied spanner, see
fig 03.
Fig 03
Fitting the Fence
Step 1 Locate the fence rail (C), fence assembly (D),
four M8 bolts (I) and washers (J). Place a washer over
the end of each bolt and lightly screw the bolts into
the threaded holes beneath the front of the table (B),
see fig 04. NOTE: Leave sufficient distance between
the bolt head and table for mounting the fence
rail.
Step 2 Find the fence rail (C), line up the half moon
cutouts with the four bolts in the table and insert the
fence rail up against the table (B), see fig 05.
B
H
Secure the fence rail (C) in position by tightening the
four bolts with the supplied spanner, see fig 06.
Fig 06
G
Step 3 Locate the fence assembly (D). Lower the
fence over the table until the clamping lever
assembly slots into the fence rail's "T" slot. NOTE:
Make sure the clamping hook to the rear of the
fence (D) has engaged over the rear of the table.
7
Assembly
I
C
Continues Over...
Fig 04
J
Fig 05

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

102266

Table of Contents