Measuring Procedure; Symbols & Units Of Display - Lutron Electronics CM-9930R Operation Manual

5. MEASURING PROCEDURE

5-1 Symbols & units of display
Symbols /
Units
Appears when selecting DCV or DCA mode.
Appears when selecting ACV & ACA mode.
Appears when the " Data hold " function is
operated.
Appears when the " Relative " function is
operated.
Battery voltage is under the low condition
already.
Appears when operating the " Automatic
range " mode.
Appears when the " Continuity beeper " is
operated.
mV, V Units for voltage measurements.
Ω , KΩ , MΩ Units for resistance measurements
Appears when the " Diode " function is
operated.
Appears when measuring a DCV or DCA
value is negative.
% Unit for " Duty cycle " measurement.
uA, mA, A Units for " Current " measurement.
Hz, KHz Units for " Frequency " measurement.
nF, uF Units for " Capacitance " measurement.
RS-232 RS-232 data send out always.
Descriptions
6