North Bridge; Graphics Configuration - Supermicro X11SAA/A2SAV/-2C/-L User Manual

P-STATE Coordination
This feature allows the user to change the P-State (Power-Performance State) coordination
type. P-State is also known as "SpeedStep" for Intel processors. Select HW_ALL to change
the P-State coordination type for hardware components only. Select SW_ALL to change the
P-State coordination type for all software installed in the system. Select SW_ANY to change
the P-State coordination type for a software program in the system. The options are HW_All,
SW_ALL, and SW_ANY.
Chipset

Warning: Setting the wrong values in the following sections may cause the system to malfunc-
tion.

North Bridge


The following memory information will be displayed:
•
Memory Slot 0
•
Memory Slot 1
Max TOLUD
This feature sets the maximum TOLUD value, which specifies the "Top of Low Usable
DRAM" memory space to be used by internal graphics devices, GTT Stolen Memory, and
TSEG, respectively, if these devices are enabled. The options are 2 GB, 2.25 GB, 2.5 GB,
2.75 GB, and 3 GB.
Graphics Configuration
GOP Configuration
GOP Driver
The Graphics Output Protocol (GOP) driver is a replacement for legacy video BIOS that
accesses UEFI protocols. The options are Enable and Disable.
IGFX Graphic Output
Use this feature to select the supported IGFX graphics device output to the EDP panel or
VGA morning. The options are VGA and Embedded Display
IGD Configuration
Integrate Graphics Device
When enabled, the onboard graphics device will be used as the primary video display. The
options are Disable and Enable.
63
Chapter 4: BIOS