X11SAA/A2SAV/-2C/-L User's Manual
4.7 RAID Level Settings
Follow the instructions below to install the Marvell firmware SW package and to set the RAID
level for a hard disk drive. Commands are in italics.
Marvell Firmware Installation
1. Contact Supermicro Technical Support to get the latest Marvell firmware SW package.
2. Save the file onto an USB flash drive and plug it into your system.
3. After booting up the system, press F11 to show the boot menu and select the first choice.
This will take you to the EFI shell.
86