Using The Handset (Remote Operation) - Panasonic KX-TG5240M Operating Instructions Manual

Using the Handset (Remote Operation)

If " " flashes, there are new messages. If there are only old messages
PLAY
" " is displayed but will not flash.
PLAY
To play back messages
1
Press the soft key (
• A beep sounds and "Please select Mailbox" will be
heard from the speaker. To switch to the
receiver, press [
C
speaker, press [s].
• The icons for mailboxes that have new
messages will flash.
2
Press the soft key (
• If "Enter Mailbox password" is announced and
displayed, Mailbox 2 or 3 has a password. Enter
the password (p. 64).
• "Mailbox (No.)" and the number of new
messages will be announced, and new
messages will be played.
• When the mailbox has no new messages, the
unit announces "Mailbox (No.)" and "No new
messages. All message playback", and plays back
all messages in the mailbox.
• To play all messages in the mailbox, press [5].
• If you do not press any buttons, the voice menu
will start (p. 68).
3
To end remote operation, press [OFF].
• If you do not select a mailbox in step 2, new messages in Mailbox 1 will be played.
• " " will remain on the display after listening to messages.
PLAY
• You can switch to another mailbox by pressing [#] and the mailbox number ([1] to
[3]) during the remote operation.
• If a call is received during playback, the unit rings and playback stops. To answer
the call, press [C] or [s]. For playback, start again from the beginning after
hanging up.
• At the end of the last message, "End of final message" is heard. The unit will
announce the remaining recoding time if it is less than 3 minutes.
• If you hear "Memory full" after playback, erase unnecessary messages (p. 69).
For assistance, please call: 1-800-211-PANA(7262)
Listening to Messages
)
.
PLAY
]. To switch back to the
, or
BOX 1 BOX 2 BOX 3
Handset
Ex. New messages exist.
7 missed calls
C I D P LAY
).
Ex. Mailbox 1 has new
messages.
Remote operation
BOX 1 BOX 2 BOX 3
C
67