Connecting Of Nbdp Terminal Unit Op05-100 (Ib-583); Dummy Load - Furuno FS-5070 Installation Manual

4.4 Connecting of NBDP Terminal Unit
OP05-100 (IB-583)
To communicate with telex, the NBDP terminal unit is required.
Name: NBDP terminal unit set, Type: OP05-100, Code No.: 000-056-956
Name Type
Terminal unit IB-583
DSP Board OP05-97
Mounting the DSP Board
1. Open the cover of the transceiver unit.
2. Remove the shield cover from the T-CPU Board (05P0732A).
3. Lay the DSP Board (supplied) on the top of the T-CPU Board, mating J5 andJ6 on the
DSP Board to J5 and J6 on the T-CPU Board. Use panhead screws (M3X8, supplied) to
fasten the DSP Board.
4. Remount the shield cover.
5. Close the cover of the transceiver unit.
4.5

Dummy Load

To short the antenna to the ship's hull when power is off, mount the optional dummy load in
the antenna coupler AT-5000.
Necessary parts (for AT-5000-H): Dummy load (Type: OP05-107, Code No.: 000-011-638)
Name
Dummy load 05P0816
Pan head screw 4x12, SWCH18A
Necessary parts (AT-5000-HS): Dummy load (Type: OP05-108, Code No.: 000-011-639)
Name
Dummy load 05P0816
Pan head screw 4x12, SWCH18A
M4x8
Code No.
000-043-435
005-951-820
Attach DSP Board
(05P0751A) here.
Type Code No.
001-020-430-00 1
000-801-070-00 4
Type Code No.
001-020-430-00 1
000-801-070-00 1
000-163-200-10 4
Qty
1 w/installation materials
1 set 05P0751A
T-CPU Board
Qty
PCB and mounting plate
Qty
PCB and mounting plate
Remarks
Remarks
Remarks
4-5