Furuno FS-5070 Installation Manual page 46

System setting of RT
Set the RT similarly with DSC. Do the setting at System setup menu at the transceiver unit.
Item
REGULATION Select the national regulation to change the
frequency, user channel, etc.
TX FREQ Select the frequency to transmit.
FREE: Any frequency can be set.
MARINE/USER: Can use the frequency and
radio type set in the marine band and the user
channel.
ITU/USER: Can use the frequency and radio
type set in the user channel or permitted with
ITU channel.
USER: Can use the frequency and radio type
set in the user channel.
AM ENABLE Select the method of AM (H3E). OFF: TX/RX are
not available. TRX: TX/RX are available. RX: RX
only is available.
LSB ENABLE Select ON to transmit/receive LSB.
TX TUNE Turn the tuning of the antenna coupler on/off.
COUPLER OFF only.
THROU
(through)
NMEA Choose the acceptable NMEA version.
TONE For maintenance.
TX POWER TX MODE
(FREQ)
TX POWEER
TX FREQ (CH)
(USER CH)
TX POWER
TX POWER ADJ
TX TONE
LOAD DEFAULT
50 Ohm BK Selects the installation situation of the 50 ohms
BK.
CW ENABLE Enable/disable the CW.
3-8
Description
Select the mode to set the TX
power.
Select the frequency to set.
Select the output level to set
TX power.
Set the TX power.
Transmit TONE.
Restore TX power settings to
default.
Setting
INTL, (RUSSIA)
FREE, MARINE/USER,
ITU/USER, USER
OFF, TRX, RX
OFF, ON
OFF, ON
OFF
V. 3.0, COMPATIBLE
2182.0 kHz
HIGH, MID, LOW1, LOW2,
TUNE
0-255, 0
OFF, ON
YES, NO
ENABLE, DISABLE
OFF, ON
Bold: default setting