Connecting Of Nbdp Terminal Unit; Inserting The Dsp Board; Mounting Location For Terminal Unit - Furuno FS-1570 Installation Manual

4.2 Connecting of NBDP Terminal Unit

OP05-96 (IB-581)/OP05-100 (IB-583)
To use this equipment for the telex, the NBDP terminal unit is required.
Name: NBDP terminal set, Type: OP05-96, Code No.: 000-056-949
Name Type
Terminal unit IB-581-02
DSP Board OP05-97
Name: NBDP terminal set, Type: OP05-100, Code No.: 000-056-956
Name
Terminal unit IB-583
DSP Board OP05-97

Inserting the DSP Board

1. Open the cover of the transceiver unit.
2. Remove the shield cover from the T-CPU Board (05P0732).
3. Attach the DSC Board (supplied) on J5 and J6 of the T-CPU Board.
4. Re-mount the shield cover.
5. Close the cover of the transceiver unit.

Mounting location for terminal unit

• Leave sufficient space around the unit for operation and maintenance.
• The temperature and humidity of the mounting location should be stable and moderate.
• Keep the unit away from the high power radiotelephone and it's feeder wire so that RFI
(Radio Frequency Interference) is minimum.
Mounting
Refer to the outline drawing at the back of this manual.
1. Fix the hanger by using five (IB-583: four) tapping screws (supplied with option kit).
2. Attach connectors to the rear of the terminal unit.
COM1
Communication
unit
Terminal unit (IB-581), rear view
3. Screw knobs to fix the terminal unit to the hanger.
Code No.
000-043-350
005-951-820
Type Code No.
000-043-435
005-951-820
Printer
PRINTER
COM2
K-BOARD
24VDC
Keyboard
For 24 VDC
Not used.
Qty
1 set w/installation materials
1 05P0751A
Qty
1 w/installation materials
1 set 05P0751A
Terminal unit (IB-583), rear view
Remarks
Remarks
4-3