Operating Instructions - Max RB515 Operating And Maintenance Manual

5. OPERATING INSTRUCTIONS

Release Lever
Release Stopper
Tie-Wire
Reel stopper
Reel holder
Tie-Wire
Reel holder
Feeding gears
Pipe
Wire guide
1 How to set the Tie-Wire
● Be sure to set the Main switch to off, to lock the Trigger, and detach the
Battery pack.
① Press the Release Lever of this equipment, and confirm that the Release Lever is
caught in the Release Stopper.
② Peel off the tape fixing Tie-Wire by about 5cm (2"). Stretch out the tip of the wound
Tie-Wire.
BE SURE TO USE ONLY THE SPECIFIED TIE-WIRE (MAX TW897).
The use of binding wire that has not been specified may cause breakdown of this
equipment. Therefore, be sure only to use the specified MAX TW897. Do not use
binding wire that has become rusted, since the use of rusted wire will cause
equipment breakdown.
③ Push the reel stopper to release the reel holder.
④ Set the Tie-Wire in the tool by matching the side of the Tie-Wire as shown in the
picture.
Then push the Reel Holder.
⑤ Insert the tip of the stretched out Tie-Wire into the wire guide.
● The tip of the Tie-Wire should be straightened out to allow it to pass through
the wire guide.
When mounting the Tie-Wire, the wire may become jammed inside the
machine if the wire tip is bent.
14