Sweep Mode; Figure 7-3 Sweep Mode Selection - Agilent Technologies U8903A User Manual

7 Sweep Function


Sweep mode

120
The available sweep modes are Auto Sweep, Manual Sweep,
Auto List, and Manual List as shown in the following figure.

Figure 7-3 Sweep mode selection

Auto Sweep
If the sweep mode is set to Auto Sweep, pressing
initiate the sweep from start to end. Sweep points are based
on the Start, Stop, and Step Size sweep parameter settings.
Manual Sweep
If the sweep mode is set to Manual Sweep, pressing
will step the next point of the sweep parameter.
You need to press
until the U8903A reaches the end of the sweep. Sweep
points are based on the Start, Stop, and Step Size sweep
parameter settings.
each time to increment the points
U8903A User's Guide
will