Mounting
1-4
System Configuration
C500/C1000H/C2000H
1-5
Mounting
The ASCII Unit can be mounted to any slot on the CPU Backplane. Before
mounting the ASCII Unit, the DIP switches must be set. Make sure that the pow-
er supply to the PC is turned OFF during installation of the ASCII Unit. A personal
computer used for entering the BASIC program should be connected to Port 1
and other peripheral I/O devices such as a printer or a display terminal can be
connected to Port 2 (refer to the following diagram). For more detailed informa-
tion on peripheral interface connections and timing, refer to Appendix B .
C120
Personal Computer
The ASCII Unit can be mounted to any I/O slot. The control panel must allow
enough space for the connectors, as shown in the figure below.
*1. Height of the ASCII Unit including the base (100
mm)
*2. Height of the ASCII Unit with an RS-232C con-
nector attached (approximately 160 to 180 mm)
CV Series
C500
Expansion
I/O Rack
Bar-code Reader
Plasma Display
Section 1-5
Printer
7