Trotec MD200 Operating Manual page 5

Menu switching on the illumination
MADE IN GERMANY
If the menu item "illumination" is activated, you can
switch the illumination on or off by briefly pressing the
"confirmation key" .
Menu display rotation
1 . briefly
MADE IN GERMANY
press simultaneously
If no submenu is selected, the display can be rotated by
180° by means of simultaneous actuation of the "Up" and
"Down" keys .
Menu calibration (Erase function)
3-4 seconds
MADE IN GERMANY
Press the "Up key" for approx . 3 to 4 seconds . Two acoustic
signals can be perceived and calibration is activated . The
EN
MD200
99
50 Hz
50 Hz
CAL
briefly
MD200
99
50 Hz
50 Hz
CAL
2 . briefly
MD200
99
50 Hz
50 Hz
CAL
Operating manual – MD200
crossed lines disappear from the "CAL" box in the display .
The present ferromagnetic basic signal is "cut" and the
measuring detectors only react to signals stronger than the
basic signal . With activated CAL menu you can carry out a
calibration any number of times .
Press and hold the "Up key" for approx . 7 s to exit "CAL"
mode again . Three acoustic signals can be perceived and
"CAL" is disabled again .
Switch-off
MADE IN GERMANY
Pressing the "Down key" for approx . 3-4 seconds switches
the device off .
MD200
99
3-4 seconds
50 Hz
50 Hz
CAL
A - 4