Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec BM31
Summary of Contents for Trotec BM31
- Page 1 BM31 ORIGINAL INSTRUCTIONS MOISTURE INDICATOR...
-
Page 2: Table Of Contents
• Do not operate the device near open electrical wiring. • Never charge batteries that cannot be recharged. • Different types of batteries and new and used batteries must not be used together. • Insert the batteries into the battery compartment according to the correct polarity. moisture indicator BM31... - Page 3 Observe the personnel qualifications! To use the device for its intended use, only use accessories and spare parts which have been approved by Trotec. Caution Keep a sufficient distance from heat sources.
-
Page 4: Information About The Device
On/off button When not in use, an automatic switch-off saves the battery. Display Device depiction Designation MAX indication MIN indication HOLD indication Battery indication Designation Measurement value indication Sensor Battery compartment with cover Operating elements Display moisture indicator BM31... -
Page 5: Transport And Storage
• the storage temperature complies with the values specified 1. Press the on/off switch (8). in the Technical data ð The display switches on. • Remove the batteries from the device. ð The device starts the calibration. moisture indicator BM31... -
Page 6: Dielectric Measurements
3. Carry out the measurement with the desired setting. Switching on the display illumination 1. Press the Lamp button (5). ð The background illumination is activated. 2. Press the Lamp button (5) again. ð The background illumination is deactivated. moisture indicator BM31... - Page 7 • Electrically conducting materials or electrical fields – If a construction material contains electrically conducting substances, the dielectric constant is also increased, which then simulates high moisture values. Consequently, a too high measured value will be displayed. moisture indicator BM31...
-
Page 8: Maintenance And Repair
EU countries on sure that no moisture enters the housing. Do not use any the website https://hub.trotec.com/?id=45090. Otherwise, sprays, solvents, alcohol-based cleaning agents or abrasive please contact an official recycling centre for electronic and cleaners, but only clean water to moisten the cloth. - Page 9 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...