Software/Driver Loading - Chelsio Communications Terminator series Installation And User Manual

Chapter III. iWARP

2. Software/Driver Loading

The driver must be loaded by the root user. Any attempt to load the driver as a regular user will
fail.
1. If not done already, load NIC and TOE drivers:
[root@host~]# kldload if_cxgbe
[root@host~]# kldload t4_tom
2. For T6, bring up the interface and enable TOE:
[root@host~]# ifconfig ccX up
[root@host~]# ifconfig ccX toe
For T5 and T4, use cxlX and cxgbeX respectively.
Note
3. Load the iWARP driver using the following command:
[root@host~]# kldload iw_cxgbe
Chelsio Unified Wire for FreeBSD
25