JLG 600SC Operation And Safety Manual page 52

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3. Platform Capacity Indicator (If equipped)
Indicates the maximum platform capacity selected for
the platform.
One of the capacity lights should be on at all times. Both
lights will flash and an alarm will sound if the platform is
out of the operating envelope for the selected capacity.
4. Drive Disabled Indicator
When illuminated, the drive function has been disabled.
(Refer to Drive Function Operating Range Diagrams in
Section 2).
5. Footswitch/Enable Indicator
To operate any function, the footswitch must be
depressed and the function selected within seven sec-
onds. The enable indicator shows that the controls are
enabled. If a function is not selected within seven sec-
onds, or if a seven second lapse between ending one
function and beginning the next function, the enable
light will go out and the footswitch must be released and
depressed again to enable the controls.
Releasing the footswitch removes power from all con-
trols and applies the drive brakes.
3-18
TO AVOID SERIOUS INJURY, DO NOT REMOVE, MODIFY OR DISABLE
THE FOOTSWITCH BY BLOCKING OR ANY OTHER MEANS.
FOOTSWITCH MUST BE ADJUSTED IF FUNCTIONS ACTIVATE WHEN
SWITCH ONLY OPERATES WITHIN LAST 1/4" OF TRAVEL, TOP OR BOT-
TOM.
6. Glow Plug Indicator
Indicates the glow plugs are operating. After turning on
ignition, wait until light goes out before cranking engine.
7. Low Fuel Indicator.
Indicates the fuel tank is 1/8 full or less. When the light
first turns on, there are approximately four usable gal-
lons of fuel remaining.
– JLG Lift – 3121156