No USB device is connected or
unsupported device is connected.
There is no disc in the unit.
No supported audio files exist in the
An unsupported USB device is
connected, or the USB device is
connected through a USB hub.
No supported video files exist in the
You tried to perform a specific
operation under conditions where
that operation is prohibited.
An over current from the
port was detected.
The USB device is write-protected.
You tried to perform an operation
that can be performed only when
the playback is stopped.
The system is reading information
of the disc or USB device. Some
operations are not available.
The transfer did not start, stopped
partway, or otherwise could not be
You cannot transfer onto the USB
device because the number of files
has reached its maximum.
When carrying the unit
To avoid damaging the disc
mechanism, perform the following
procedure before carrying the unit.
Use the buttons on the unit to
perform this operation.
Press to turn on the system.
Press FUNCTION repeatedly to
Remove the disc.
Press to open and close the disc
Wait until "NO DISC" appears on the
Press to turn off the system.
Unplug the AC power cord (mains
Notes on discs
Before playing, wipe the disc with a
cleaning cloth from the center outward
to the edge.
Do not clean discs with solvents, such
as benzine, thinner, or commercially
available cleaners or anti-static spray
intended for vinyl LPs.
Do not expose discs to direct sunlight
or heat sources such as hot air ducts,
nor leave them in a car parked in direct
Completely disconnect the AC power
cord (mains lead) from the wall outlet
(mains) if it is not going to be used
for an extended period of time. When
unplugging the system, always grip the
plug. Never pull the cord itself.
Should any solid object or liquid get
into the system, unplug the system, and
have it checked by qualified personnel
before operating it again.