Sony MHC-V41D Operating Instructions Manual page 74

There is severe hum, noise, or
distorted sound.
If there are obstacles between
• •
the system and your BLUETOOTH
device, remove or avoid the
obstacles.
If there is equipment that
• •
generates electromagnetic
radiation, such as a wireless LAN,
other BLUETOOTH device, or a
microwave oven nearby, move
them away.
Turn down the volume of the
• •
connected BLUETOOTH device.
Gesture control
The gesture control cannot be
activated.
Press GESTURE ON/OFF
• •
repeatedly until GESTURE ON/OFF
indicator lights up.
Make sure the Child Lock function
• •
is not activated (page 67).
The gesture control does not
operate properly.
Move your hand closer to
• •
GESTURE CONTROL (page 48)
when you perform the swiping
motion.
Perform the swiping motion at a
• •
slower speed.
Select the correct mode
• •
(PLAYBACK, DJ, SAMPLER or
KARAOKE) before you start using
the gesture control (page 48,
50).
Install a noise filter (not supplied)
• •
to the AC power cord (mains lead).
Turn off surrounding electrical
• •
equipment.
74
GB
Control for HDMI
("BRAVIA" Sync)
The system does not turn on even
when the TV is turned on.
Hold down SHIFT and press
• •
SETUP, then set [HDMI SETUP]
– [CONTROL FOR HDMI] to [ON]
(page 36). The TV must support
the Control for HDMI function
(page 52). For details, refer to
the operating instructions of your
TV.
Check the speaker settings of the
• •
TV. The system power syncs with
the speaker settings of the TV.
For details, refer to the operating
instructions of your TV.
If the sound was output from the
• •
TV's speakers the previous time,
the system does not turn on even
when the TV is turned on.
The system turns off when the TV
is turned off.
Check the setting of [HDMI SETUP]
• •
– [STANDBY LINKED TO TV]
(page 36). When
[STANDBY LINKED TO TV] is set
to [ON], the system turns off
automatically when you turn off
the TV regardless of the input.
The system does not turn off even
when the TV is turned off.
Check the setting of [HDMI SETUP]
• •
– [STANDBY LINKED TO TV] (page
36).
To turn the system off
automatically regardless of the
input when you turn off the TV, set
[STANDBY LINKED TO TV] to [ON].
The TV must support the Control
for HDMI function (page 52).
For details, refer to the operating
instructions of your TV.