2019/02/28 22:48:45 (GMT+09:00)
SERVICE MANUAL
Ver. 1.0 2019.03
Note:
Be sure to keep your PC used for service and
checking of this unit always updated with the
latest version of your anti-virus software.
In case a virus aff ected unit was found during
service, contact your Service Headquarters.
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(US models only)
Left/Right Channel:
With 5 ohm loads, both channels driven, from 700 Hz – 20,000 Hz;
rated 6 watts per channel minimum RMS power at stereo mode,
with no more than 0.7% total harmonic distortion from 250
milliwatts to rated output.
Speaker section
Speaker system:
2-way, Bass Reflex
Speaker unit:
Tweeter L/R: 40 mm (1 5/8 in), cone type
Woofer: 180 mm (7 1/8 in), cone type
Inputs
AUDIO IN L/R:
Voltage 2 V, impedance 47 kilohms
MIC/GUITAR:
Sensitivity 1 mV, impedance 10 kilohms
(When guitar mode is turned off .)
Sensitivity 200 mV, impedance 1 Megaohm
(When guitar mode is turned on.)
Disc player section
System:
Compact disc and digital audio system
Laser Diode Properties
Emission Duration: Continuous
Laser Output*: Less than 44.6 μW
* This output is the value measurement at a distance
of 200 mm from the objective lens surface on the
Optical Pick-up Block with 7 mm aperture.
Frequency response:
20 Hz – 20 kHz
USB section
Supported USB device:
Mass Storage Class
Maximum current:
1 A
(USB) port:
Type A
9-890-699-01
2019C80-1
©
2019.03
FM tuner section (Except AEP, UK)
FM stereo, FM superheterodyne tuner
Antenna:
Tuning range:
BLUETOOTH section
Communication system:
Output:
Maximum output power:
Maximum number of devices to be registered:
Maximum number of simultaneous connection
(Multipoint):
Maximum communication range:
Frequency band:
Modulation method:
Compatible BLUETOOTH profiles
Supported codecs:
1)
The actual range will vary depending on factors such
as obstacles between devices, magnetic fields around a
microwave oven, static electricity, reception sensitivity,
antenna's performance, operating system, software appli-
cation, etc.
2)
BLUETOOTH standard profiles indicate the purpose of
BLUETOOTH communication between devices.
Supported audio formats
Supported bit rate and sampling frequencies:
Sony Corporation
Published by Sony EMCS (Malaysia) PG Tec
MHC-V02
Model Name Using Similar Mechanism
Optical Pick-up Name
SPECIFICATIONS
FM lead antenna
87.5 MHz – 108.0 MHz (50 kHz step) (Except US)
87.5 MHz – 108.0 MHz (100 kHz step) (US model)
BLUETOOTH Standard version 4.2
BLUETOOTH Standard Power Class 2
<9.5 dBm
8 devices
3 devices
Line of sight approx. 10 m (32 ft)
1)
2.4 GHz band (2.4000 GHz – 2.4835 GHz)
FHSS (Freq Hopping Spread Spectrum)
:
2)
A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio Video Remote Control Profile)
SPP (Serial Port Profile)
SBC (Subband Codec)
AAC (Advanced Audio Coding)
LDAC
MP3:
32/44.1/48 kHz, 32 kbps –
320 kbps (VBR)
US Model
Canadian Model
AEP Model
UK Model
E Model
Australian Model
ZS-RS80BT
EM101UBS WITH PWB, MOTOR
AAC:
8/11.025/16/22.05/32/44.1/48 kHz,
5 kbps – 384 kbps (VBR)
WMA:
8/11.025/16/22.05/32/44.1/48 kHz,
48/64/96/128/160/192 kbps (CBR),
64 kbps – 161 kbps (VBR)
WAV:
8/11.025/12/16/22.05/24/32/44.1/
48 kHz (16 bit)
General
Power requirements:
AC 120 V, 60 Hz (US model)
AC 120 V – 240 V, 50/60 Hz (Except US)
Power consumption:
25 W
Power consumption (at the Power Saving mode):
0.5 W (When "BT STBY" is set to "OFF".)
2 W* (When "BT STBY" is set to "ON".)
Dimensions (W/H/D) (Approx.):
281 mm × 500 mm × 306 mm
(11 1/8 in x 19 3/4 in x 12 1/8 in)
Mass (Approx.):
6 kg (13 lb 4 oz)
Operating temperature:
5 °C to 35 °C (41 °F to 95 °F)
* The power consumption of the system will be less than
0.5 W when "BT STBY" is set to "OFF".
Supplied accessories
Remote control (DC 3 V) (1)
R03 (DC 1.5 V) (size AAA) batteries (2)
FM lead antenna (aerial) (1) (supplied only for
certain areas)
AC power cord (mains lead) (1)
AC plug adaptor* (1) (supplied only for certain
areas)
* This plug adaptor is not for the use in Chile,
Paraguay and Uruguay. Use this plug adaptor in
the countries/regions where it is necessary.
Design and specifications are subject to change without
notice.
– Continued on next page –
HOME AUDIO SYSTEM
SYS SET
Need help?
Do you have a question about the MHC-V02 and is the answer not in the manual?
Questions and answers
No enciende
The Sony MHC-V02 may not turn on if the AC power cord is not connected to the AC IN jack on the rear of the system.
This answer is automatically generated
se me dañaron los conectores flex hacia los controles y necesito conectar un dispositivo de audio externo para reproducir el sonido, por loque necesito conectarlo directamente a la tarjeta electronica del amplificador sin necesidad de los controles originales