Application; Disassembling, Cleaning And Assembling - Storz & Bickel GMBH MIGHTY Instructions For Use Manual

9. APPLICATION

Mount the Cooling Unit on the Vapor-
izer and heat up. This ensures that
both the Filling Chamber and the ma-
terial to be vaporized are preheated
and the vaporizing can begin as soon
as the heating process is completed.
Caution! Hot surface!
After using the MIGHTY Va-
porizer, do not touch the Fill-
ing Chamber until it has cooled down
again.
Once the Vaporizer has reached the
set temperature (set and actual tem-
peratures are the same, also signaled
by a short double vibration) and the
Mouthpiece is folded out, the inhaling
process can then begin.
Using the MIGHTY Vaporizer
Take the Mouthpiece between the
lips, and inhale slowly and evenly for
several seconds.
Please note the following about va-
por generation: the more intense the
vapors, the greater the impairment of
the flavor.
A very high intensity (density)
of the vapor can lead to irrita-
tion of the respiratory pas-
sages from the concentration of the
aromas and fragrances.
In this case, the temperature should
be lowered, so that the intensity of the
vapors is reduced.
The device is not to be used, if
the user has respiratory tract
or lung conditions. Depend-
ing on the density, the vapor could ir-
ritate respiratory tracts or lungs,
which can lead to coughing.
Inhale only half of air you can
normally manage. Hold your
breath for a few seconds and
exhale slowly. It is advisable to delib-
erately concentrate on your breathing
process.
After vaporization, turn off
MIGHTY Vaporizer. To do this, press
the orange ON/OFF switch for at least
half a second. The Vaporizer acknowl-
edges the switching off with a short
vibration.
Pull the power adapter (if it is used)
from the socket and disconnect from
the Vaporizer.
Allow the Vaporizer and the power
adapter to cool down before they are
packed away.
22

10. DISASSEMBLING, CLEANING AND ASSEMBLING

When the vapors are cooled, it is in-
evitable that a small fraction is con-
densed on the internal surfaces of the
Cooling Unit.
The component parts of the Cooling
Unit, including the Mouthpiece must
be thoroughly cleaned on a regular
basis to guarantee proper operation
and pure flavor.
Product Overview of the MIGHTY Cooling Unit
The Cooling Unit consists of:
Cap Lock
Mouthpiece
Mouthpiece Seal Ring
Cooling Unit Cap
the
Base Seal Ring
(small)
Cooling Unit Base
Upper Screen
(coarse mesh width)
Base Seal Ring
(large)
For hygienic reasons, it is also neces-
sary to clean these components when
the Vaporizer is to be used by a differ-
ent person.
The condensate can
sticky. The Cooling Unit can
be dismantled more easily
when it first warmed up.
23
be