Installation - Acson A4LC 10 B Manual

Sharp edges and coil surface are potential injury hazard. Avoid from contact with them.
(1) INSTALLATION OF INDOOR UNIT
For installation of indoor unit, please refer to the indoor unit technical manual.
(2) INSTALLATION OF OUTDOOR UNIT
As condensing temperature rises, evaporating temperature rises and cooling capacity drops. In order to
achieve maximum cooling capacity, the location selected for outdoor unit should fulfill the following
requirements :-
•
Install the condensing (outdoor) unit in a way such that hot air distributed by the outdoor condensing
unit cannot be drawn in again (as in the case of short circuit of hot discharge air). Allow sufficient
space for maintenance around the unit
•
Ensure that there is no obstruction of air flow into or out of the unit. Remove obstacles that block air
intake or discharge.
•
The location must be well ventilated, so that the unit can draw in and distribute plenty of air thus
lowering the condensing temperature.
•
A place capable of bearing the weight of the outdoor unit and isolating noise and vibration.
•
A place protected from direct sunlight. Otherwise use an awning for protection, if necessary.
•
The location must not be susceptible to dust or oil mist.

6. INSTALLATION

Caution
.
11