Isdn Terminal Equipment (Isdn Phone, G4 Fax, Etc) (Figure 6-5); Connecting Isdn Terminal Equipment - Samsung DCS 816 Installation Manual

SAMSUNG
DCS-816
6.6 ISDN TERMINAL EQUIPMENT (ISDN phone, G4 FAX, etc)
(Figure 6-5)
ISDN Terminal Equipment (TE) can be connected to any circuit on the BRI card if installed. As de-
scribed in section 5.4, the system provides S
tem requires MDF connection for a BRI card and the connection can be made through the Champ
connector. See Figure 2-3 and refer to section 2.5 (MDF Cabling).
Use two pair twisted wires and connect each ISDN TE to the BRI port of your choice via the
Champ connector on the base board.
Note that the DCS Compact BRI card does not provide power to the ISDN terminal equipment.
25 PAIR CABLE WITH FEMALE CONNECTOR TO THE BASE CHAMP CONNECTOR
ISDN TEs

CONNECTING ISDN TERMINAL EQUIPMENT

as well as T
0 0
CHAMP CONNECTION
PIN COLOUR
28/ 3 W-GR/ GR-W
29/ 4 W-BR/ BR-W
30/ 5 W-S/ S-W
31/ 6 R-BL/ BL-R
32/ 7 R-O/ O-R
33/ 8 R-GR/ GR-R
34/ 9 R-BR/ BR-R
35/10 R-S/ S-R
CONNECT ISDN TE TO ANY BRI PORT WHEN A
BRI CARD IS INSTALLED
NO POWER SUPPLY TO ISDN TE
6-6
Installation Manual
application on a port basis. The sys-
CIRCUITS / FUNCTIONS
st
T/R, TX of 1 BRI port
st
T/R, RX of 1 BRI port
nd
T/R, TX of 2 BRI port
nd
T/R, RX of 2 BRI port
rd
T/R, TX of 3 BRI port (4BRI)
rd
T/R, RX of 3 BRI port (4BRI)
th
T/R, TX of 4 BRI port (4BRI)
th
T/R, RX of 4 BRI port (4BRI)
FIGURE 6-5