Memory Buttons; Loading A Program; Starting - Interrupting - Stopping - Retsch GRINDOMIX GM 200 Operating Instructions Manual

Fig.13
Fig.14

22.02.2002 Retsch GmbH & Co. KG

Memory buttons

The GRINDOMIX GM 200 has three memory buttons J, which can be
used to save parameter combinations of time and speed. Fig.13
• Turn the main switch on.
• Displays E and G indicate the last parameters set.
• Set the time with knob F.
• Set the frequency with knob H.
• Hold one of the three memory buttons J depressed. After 1.5 seconds,
displays E and G flash.
• When the displays stop flashing, the parameters are stored under the
memory key which was pressed.

Loading a program

• Press the corresponding memory button J, Fig.13, briefly.
The saved parameters then appear on displays E and G.
• Start the GRINDOMIX GM 200.

Starting - Interrupting - Stopping

Starting: Fig. 14
• Press the START button C.
During the milling period, the speed is kept constant within a specified
tolerance.
Interrupting: Fig.14
• Press the STOP button D.
The milling process is interrupted and can be resumed for the remaining
running time by pressing the START button C again.
Stopping: Fig.14
• Press the STOP button D twice.
The milling process is stopped, the cover springs open and the original
machine running time is displayed.
18
Doc.no. GB 98.251.9999 C