Table of Contents
Advertisement
Building an IP surveillance system
Refer to the following procedure to set up an IP surveillance
system with many pairs of the VC-232G:
1. Set the VC-232G to be CO and CPE mode from the DIP
switch on the rear panel.
2. Power on the VC-232G by connecting its power source.
3. Power LED will illuminate.
4. Connect coaxial cable to the VDSL ports of two VC-232G
units.
5. VDSL LED will blink to illuminate.
6. Connect Ethernet port to IP cameras via regular Cat. 5, 5e or
6 cable.
7. Install the NVR and monitor and connect to one Ethernet
switch
8. You can get data transmissions from all IP cameras.
Installing Ethernet over Coaxial Converter
16
Advertisement
Table of Contents
