Olympus DP21 Instructions Manual page 18

2
1
14
Fig. 6
Disconnecting the AC Adapter
Press the main switch @ of the control box to shut down the DP21 and
confirm that the POWER LED ² is turned off completely (about 10 sec.)
before unplugging the connector of the AC adapter.
Unplugging the connector while POWER LED ² is lit will result
CAUTION
in malfunction or damage.
Do not use the system if the AC adapter plug is inserted incom-
pletely.
Never plug or unplug the AC adapter plug with a wet hand.
In the case of abnormality with the AC adapter or cord, such as ab-
normal heat generation, scorched smell or smoke, immediately un-
plug the power cord from the power outlet and stop using the sys-
tem. Also contact Olympus immediately.
Never use an AC adapter other than the designated AC adapter.
Otherwise, a failure of the control box, camera head or power supply,
or an incident including a fire hazard may result. Note that Olympus
will not warrant damage incurred due to the use of a non-designated
AC adapter.
Never pull, bend, twist the AC adapter cord excessively or use an
extension cord.
If the AC adapter cord is scratched, the internal conductor is discon-
nected or the plug has a contact failure, immediately contact Olympus.
When the system is not used, be sure to unplug the AC adapter from
the power outlet.
When connecting the power cord to a wall outlet, do not use a multi-
outlet extension or a table tap with multiple outlets. Otherwise, a fire
hazard may result.
CAUTION