Olympus DP21 Instructions Manual page 17

2
@
Fig. 4
@
³
2
|
Fig. 5
4
Connecting the Display Cable
Insert the connector @ of the cable provided with the display all the way
into the connector ² on the control box and secure the clamping screws
on both sides of the connector.
}Use a DVI cable matching the display as the display cable. The DP21 is
compatible with either the DVI-I, D or A connector.
5
Connecting the AC Adapter
CAUTION · Always use the AC adapter provided by Olympus. Using other
AC adapter will result in malfunction or damage.
5
· The cords and cables are vulnerable to bend or twist. Do not
apply excessive force to them.
1. Pass the cable of the AC adapter through the holder @ on the control
box and close the holder @ securely. This measure is required to prevent
the cable from easily disconnecting from the control box.
2. Insert the output connector ² of the AC adapter into the DC input con-
nector ³ of the control box.
Always use the power cord provided by Olympus. If no power
CAUTION
cord is provided with the camera head, please select the proper
power cord by referring to chapter "PROPER SELECTION OF
THE POWER SUPPLY CORD" at the end of this instruction
manual.
3. Insert the connector | of the power cord into the input connector 5 of
the AC adapter.
4. Insert the power cord plug into the power outlet. Connect the power cord
correctly and ensure that the grounding terminals of the power supply
and wall outlet are properly connected. If the equipment is not grounded/
earthed, Olympus can no longer warrant the electrical safety performance
of the equipment.
}The AC adapter and control box generate heat after long hours of use,
but this is not malfunction.
SAL System
(Fig. 4)
(Fig. 5)
13