Setting Favorite Channels; Starting A Scan - Icom IC-M330 Instruction Manual

5
SCAN OPERATION (Except for the Dutch Version)

■ Setting Favorite channels

You can quickly recall often-used channels by setting them
as Favorite channels. You can set Favorite channels in each
Channel Group.
1. Select a Channel Group. (p. 10)
2. Push [▲] or [▼] to select the channel you want to set as
a Favorite channel.
3. Push [◄] or [►] to display
4. Push .
• The selected channel is set as a Favorite channel, and
" " is displayed.
L To cancel the setting, push
TIP: You can set all channels as Favorite channels, clear all
settings, or reset to the default. By default, some channels
are preset as Favorite channels. The preset channels differ,
depending on the transceiver version.
Example: Starting a Normal Scan.
16
.
again.
Push to start

■ Starting a scan

1. Select a Channel Group. (p. 10)
2. Push [◄] or [►] to display
3. Push .
SCAN
• The scan starts.
• "
" " is displayed during a Normal Scan.
L When a signal is received, the scan pauses until the signal
disappears, or resumes after 5 seconds, depending on the
Scan Timer setting in "Radio Settings."
L A beep sounds and "16" blinks when a signal is received on
Channel 16 during a Priority scan.
4. To stop the scan, push
TIP: To properly receive signals, be sure to adjust the squelch to a
suitable level.
While scanning
" " is displayed.
SCAN .
" is displayed during a Priority Scan, and
.
SCAN
When a signal is received
" " and " " are displayed.