Table of Contents
Advertisement
4.3 Cleaning the Rollers
When ink or paper dust is stuck on the imprinter feed
roller surfaces, documents may not feed smoothly.
To prevent feed problems, clean the roller surfaces
regularly.
ATTENTION
It may take a long time to dry if an excessive
amount of Cleaner F1 is used. Use it in small
quantity. Wipe off the cleaner completely to leave
no residue on the cleaned parts.
HINT
The recommended cleaning cycle is every 5,000
sheets. The actual cleaning cycle may be shorter
depending on how often the imprinter is used and
the documents.
1
Open the print section.
2
Clean the rubber rollers.
Clean the rubber rollers (eight in total) under the
feeding section.
Print Section
Gently wipe the dirt and dust off the surface of the
rollers with a cloth moistened with Cleaner F1.
Clean the entire surface of the rubber rollers as you
rotate them manually.
ATTENTION
When cleaning, be careful not to touch the metal
wheels located at the print section.
Rubber Rollers
3
Clean the plastic rollers.
Clean the two plastic rollers (black) at the print
section.
Print Section
Rotate the rollers manually while gently wiping the
dirt and dust off the surface of the rollers with a
cloth moistened with Cleaner F1.
4
Confirm that the dirt is removed and then close the
print section.
4.4 Cleaning Materials
Name
Cleaner F1
Cleaning Wipe
*1: Pre-moistened with Cleaner F1. It can be used
instead of moistening a cloth with Cleaner F1.
ATTENTION
In order to use the cleaning materials correctly and
safely, read the precautions on each product
thoroughly.
For information about the cleaning materials, contact
your FUJITSU scanner dealer or an authorized
FUJITSU scanner service provider.
19
Plastic Rollers
Part No.
Notes
PA03950-
Volume: 100 ml
0352
PA03950-
24 packets
0419
(*1)
Advertisement
Table of Contents
